RX2-1K GAS
RECEIVER FOR 1 GASPROJECTOR
The RX2-1K GAS is a receiver used to control the gasprojector GX2 12V via radio. The receiver allows the control of the single projector, as well as activating predefined sequences in combination with other RX2-1K GAS'.
By use of the ShowCreator and AutoShow Software it is possible to create almost any sequence wanted with the RX2-1K GAS. The internal Timecode synchronization of automated shows allows the ignition of multiple gasprojectors and steppsequences with milliseconds of delays.
FEATURES
- Safe, multiple times encrypted radio control.
- Easy control thanks to predefined sequences.
- Own sequences can be added fast and easily into automated shows.
- No cables between projectors are needed.
- Settings can be adjusted directly from the transmitter.
| Number of projectors: | 1 |
| Measurements: | 150 x 50 x 70mm |
| Weight: | 0,3kg |
| Power Supply: | From the GX2 |
| Case: | Plastic |
| Radio range: | 500m |
Current software and manual for this product:
Attention: Please note that there are multiple hardware versions for this product, who will need a different software. Always make sure to load the correct software onto the right product. Should you not be sure which update to select, please do not hesitate to contact us.
With every receiver update we recommend to update your transmitters (TX2-70K, TX2-Stage)!
Check the ID-number label on the top of your receiver. Should you read "Platine V5" underneath the ID, select the software for the V5 circuitry.
WEITERE PRODUKTE
RX2-30K in case
Timecode Modem
CO2-Jet 230V
GX2 12V
X2 Power Flame
SFX Torch
