With the stepper software, it’s possible to program any stepp sequences to the receivers. The in no longer general use channels remain adequate firing channels. Times of 40ms up to 120sec in 20ms steps pro channel, are possible. Because of the graphic construction, and easy appliance, it’s possible to program in short time complex stepp sequences. E.g.: Asynchrony or accelerated sequences. They stored until the next activation. Box/Nr. and firing channels can be via the software freely assigned. There are no more limits to a pyro technicians creativity.

After successful creation and simulation at the  PC, the sequence assigns 
Via the cutting side cable to the receivers. The activation of the stepp sequences happens via wireless through the firing of the star channels. It’s possible to use sequences from 2 up to 70 channels in the different combinations. Because of the exact deceleration, the sequences can be used instead of Pre-burners.

Download - Flyer

Program runs with Windows 2000, XP und Vista
Minimum 256 MB RAM (512 MB RAM recommended)
Minimum 30 MB free hard disk storage
Dump via USB adapter (RS232 serial) Com1, Com2